Arctic Air for R12 Systems – 8 × 4 oz Cans – A/C Booster & Moisture Remover
Restore the Cold to Your R12 A/C System
If you drive a classic car or operate older equipment that still runs on R12 refrigerant, you know how tough it can be to keep the air conditioning working at its best. R12 systems are aging, refrigerant is expensive, and performance often isn’t what it used to be. That’s where Arctic Air for R12 Systems comes in.
This product is not a refrigerant. Instead, it’s an additive treatment designed to boost cooling, protect your system, and extend its life. Arctic Air is packaged in a convenient 4 oz aerosol can and installs just like refrigerant — but instead of filling the system, it works alongside your existing refrigerant to:
-
💧 Remove damaging moisture that causes freeze-ups, corrosion, and acid buildup.
-
❄️ Enhance cooling performance by reducing friction inside the compressor, helping your vents blow colder air.
-
🛠️ Protect critical components by conditioning the oil in the system, allowing parts to run smoother and last longer.
Why R12 Systems Benefit from Arctic Air
R12 systems are decades old, and many are running without the same efficiency they once had. Over time, small amounts of water can sneak into the closed loop, causing ice blockages or rust. At the same time, compressor oil breaks down, leaving parts dry and creating extra heat. Arctic Air addresses both issues in one can, giving your A/C the support it needs without expensive repairs.
Key Benefits
-
✅ Colder air – Helps restore vent temps closer to what they were when your system was new.
-
✅ Moisture protection – Prevents internal corrosion and freeze-ups.
-
✅ Extended system life – Reduces strain on your compressor and moving parts.
-
✅ Easy to install – Works with a standard charging hose (134a-style top).
-
✅ Affordable upgrade – Simple, cost-effective way to get more out of your R12 system.
How to Use
-
Shake the can well.
-
Attach a can tap and charging hose (134a-style fitting).
-
Connect to the low-pressure port only.
-
Invert the can and allow the contents to flow into the system.
-
Run the A/C for about 30 minutes to circulate.
⚠️ Important Notes:
-
Do not use in CO₂ or ammonia systems.
-
Do not add to a fully charged system — always check system pressures first.
-
This product is not a refrigerant — it’s a performance booster designed for use with R12.